Cisco Nexus 3548 series - Verifying the RMON Configuration

On startup enable rising or falling alarm
Configuring RMON Events
You can configure RMON events to associate with RMON alarms. You can reuse the same event with multiple
RMON alarms.
Ensure you have configured an SNMP user and enabled SNMP notifications.
Before you begin
Ensure that you have configured an SNMP user and enabled SNMP notifications.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Configures an RMON event. The description
string and owner name can be any alphanumeric
string.
switch(config)# rmon event index [description
string] [log] [trap] [owner name]
Step 2
Displays information about RMON alarms or
high-capacity alarms.
(Optional) switch(config)# show rmon {alarms
| hcalarms}
Step 3
Saves this configuration change.(Optional) switch# copy running-config
startup-config
Step 4
Verifying the RMON Configuration
Use the following commands to verify the RMON configuration information:
PurposeCommand
Displays information about RMON alarms.show rmon alarms
Displays information about RMON events.show rmon events
Displays information about RMON hcalarms.show rmon hcalarms
Displays information about RMON logs.show rmon logs
Default RMON Settings
The following table lists the default settings for RMON parameters.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
112
Configuring RMON
Configuring RMON Events