Cisco Nexus 3548 series - Page 184

Procedure
PurposeCommand or Action
Displays information about a specific SPAN
session, all SPAN sessions, or a range of SPAN
sessions.
switch(config)# show monitor session
{number | all | range}
Step 1
Displays information about only the Warp
SPAN sessions.
switch(config)# show monitor session warp
Step 2
Example
This example shows how to display information about all SPAN sessions and only the Warp SPAN
sessions:
switch(config)# show monitor session all
session warp
---------------
type : local
state : up
source intf :
rx : Eth1/36
tx :
both :
source VLANs :
rx :
destination ports : Eth1/1 Eth1/2 Eth1/3 Eth1/4
Legend: f = forwarding enabled, l = learning enabled
switch(config)# show monitor session warp
session warp
---------------
type : local
state : up
source intf :
rx : Eth1/36
tx :
both :
source VLANs :
rx :
destination ports : Eth1/1 Eth1/2 Eth1/3 Eth1/4
Legend: f = forwarding enabled, l = learning enabled
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
170
Configuring Warp SPAN
Verifying Warp SPAN Mode Configuration