Cisco ONS 15454 - Init-Reg-<Mod2; Sched-Pmrept-<Mod2; Rtrv-Pmsched-<Mod2; Rept Pm <Mod2

2-65
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.10.6 INIT-REG-<MOD2>
Output Format SID DATE TIME
M CTAG COMPLD
“<AID>:<CONDTYPE>,[<CONDEFF>],[<OCRDAT>],[<OCRTM>],[<LOCN>],,[<MONVAL>],
[<THLEV>],[<TMPER>]:[<DESC>],[<AIDDET>]”
;
Output Example VA454-23 2000-02-20 08:47:03
A 512.512 REPT EVT G1000
“FAC-2-1,G1000:T-ETHERSTATSOCTETS-HT,TC,09-30,23-59-59,,,1003,
1000,:\“RMON THRESHOLD CROSSING ALARM # 1 \”,G1000-4”
;
2.10.6 INIT-REG-<MOD2>
This command initializes the PM registers.
This command applies to G1K-4, GIGE, FSTE, and FC data objects.
Only RAW-DATA is allowed to be specified for TMPER because no history data will be cleared for
RMON-managed PMs by INIT-REG-<MOD2>.
2.10.7 SCHED-PMREPT-<MOD2>
This command schedules/reschedules the NE to report the performance monitoring data.
The three accumulation time periods form RMON statistics are: 1-MIN, 1-HR, and RAW-DATA.
2.10.8 RTRV-PMSCHED-<MOD2>
This command retrieves the RMON statistics reporting schedule that was set for the NE by the
SCHED-PMREPT-<MOD2> command.
The LOCN parameter is optional in the output of RTRV-PMSCHED-<MOD2>, and no LOCN
information will be given in the output of RTRV-PMSCHED for RMON PM schedule.
2.10.9 REPT PM <MOD2>
Reports autonomous monitoring statistics as a result of the schedule created by
SCHED-PMREPT-<MOD2>.
The LOCN parameter is optional in the output of REPT PM <MOD2> message, and no LOCN
information will be given in the output of REPT PM <MOD2>.