2-80
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.12.19 Overhead Circuit Provisioning Rules
2.12.19 Overhead Circuit Provisioning Rules
1. LOW/EOW is possible between the AIC-I, OCn and TXP/TXPP cards in any combination in
line-terminated mode.
2. F1/D4-D12 UDC:
a. Not possible between TXP/TXPP and AIC-I cards in line-terminated mode.
b. Not possible between TXP/TXPP and OCn cards in line-terminated mode.
c. Possible between OC-N ports.
3. All OH bytes are passed across client and DWDM ports in transparent mode.
4. SDCC/LDCC tunneling is not possible in line-terminated mode.
5. No end-to-end OH circuit provisioning. In Release 6.0 you can stitch them at each node.
6. For MXP_MR_2.5G and MXPP_MR_2.5G cards these rules apply to the trunk port only.
2.12.20 Hardware Limitation Rules
1. ESCON SFP does not support any monitoring.
2. Optics thresholds and PM are not shown on client ports.
3. HI/LO-TXPOWER is not supported for TXP_MR_2.5G and TXPP_MR_2.5G Cards.
To Next Page
Loading...
