1-4
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 1 General Information
1.3.1 General Rules
1.3.1 General Rules
1.3.1.1 Explicit List of AIDs - No Wildcards
If a set of AIDs is explicitly listed, including a set of just one AID, then each AID must complete
successfully to return a COMPLD message. If more than one AID is in the set and at least one AID
succeeds but all do not, then a PRTL with errors for each failed AID is returned. If all AIDs in the set
fail, a DENY with errors for each failed AID is returned.
SLOT-1
FAC-2-1&FAC-3-3&FAC-4-2
1.3.1.2 Implicit List of AIDs - Single AID With Wildcard
If a set of AIDs is implied by the use of the ALL modifier on a single AID, then follow the same rules
as in the “1.3.1.1 Explicit List of AIDs - No Wildcards” section on page 1-4. The caveat is that the
implicit list only includes AIDs that apply to the command:
SLOT-ALL
FAC-1-ALL
STS-3-ALL
where Slot 3 contains an OC-12 and the command is ED-STS1 but STS-3-4 and STS-3-7 are STS3C.
The set implied by STS-3-ALL only contains STS-3-{1,2,3,10,11,12} and will not return an error for
STS-3-{4,5,6,7,8,9}. Disregard the STS3C in this case because the modifier of the command specifies
that the user is only interested in STS-1 paths. The rule specified in this section applies to the implicit
set of {1,2,3,10,11,12}.
1.3.1.3 Explicit List Grouped With Implicit List
If the set of AIDs is comprised of two subsets, one set including explicitly stated AIDs and the other set
implied by one or more AID(s) with the ALL modifier, then follow the rules of the“1.3.1.1 Explicit List
of AIDs - No Wildcards” section on page 1-4 and the “1.3.1.2 Implicit List of AIDs - Single AID With
Wildcard” section on page 1-4, respectively.
FAC-1-1&FAC-2-ALL
FAC-3-ALL&FAC-7-ALL
STS-2-ALL&STS-12-1&STS-13-2&STS-14-ALL
1.3.2 Command Completion Behavior for Retrieval of Cross-Connections
When you enter a RTRV-CRS command, one of three completion codes will be returned. The completion
codes are: COMPLD, PRTL, and DENY. You can specify an explicit, implicit, or explicit with implicit
list as explained in the following sections.
To Next Page
Loading...
