Cisco ONS 15454 - Rept Evt Fxfr; Downloading New Software; Download New Software

2-45
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.6.3 REPT EVT FXFR
2.6.3 REPT EVT FXFR
REPT EVT FXFR is an autonomous message used to report the start, completion, and completed
percentage status of the FTP software download. REPT EVT FXFR also reports any failure during the
software upgrade including invalid package, invalid path, invalid userid/password, and loss of network
connection.
Note:
1. The “FXFR_RSLT” is only sent when the “FXFR_STATUS” is COMPLD.
2. The “BYTES_XFRD” is only sent when the “FXFR_STATUS” is IP or COMPLD.
Output format:
Example 2-32 SID DATE TIME
A ATAG REPT EVT FXFR
“<FILENAME>,<FXFR_STATUS>,[<FXFR_RSLT>],[<BYTES_XFRD>]”
;
where:
• <FILENAME> indicates the transferred file path name and is a string. When a package is being
transferred between the FTP server and the controller cards, the filename field will contain the string
“active”. Following this transfer, if there is a second controller card on the node, the file will be
copied over to the second card. While this is happening, REPT EVT FXFR messages will be
generated with a filename of “standby”.
• <FXFR_STATUS> indicates the file transferred status: Start, IP (in progress), or COMPLD.
• <FXFR_RSLT> indicates the file transferred result: success or failure. <FXFR_RSLT> is optional
• <BYTES_XFRD> indicates the transferred byte count. <BYTES_XFRD> is a string and is optional
2.6.4 Downloading New Software
The following procedure downloads new software to the TCC2/TCC2P, XTC, 15310-CL-CTX or TSC
card using TL1.
Download New Software
Note Only Superusers can download and activate software.
Step 1 Copy the new software package (15454-0340-X02E-2804.pkg) to an FTP host.
Step 2 Establish a TL1 session with the target NE.
Step 3 Login with the ACT-USER command.
Step 4 Check the working and protect software on the NE by issuing the RTRV-NE-GEN command.