2-46
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.6.4 Downloading New Software
Input example:
Example 2-33 RTRV-NE-GEN:::1;
Output example:
Example 2-34 VA454-94 1970-01-06 22:22:12
M 1 COMPLD
“IPADDR=10.82.87.94,IPMASK=255.255.255.224,DEFRTR=10.82.86.1,
ETHIPADDR=10.82.87.94,ETHIPMASK=255.255.255.224,NAME=VA454-94,
SWER=3.40.00,LOAD=03.40-002G-14.21,PROTSWVER=4.00.00,
PROTLOAD=04.00-X02G-25.07,DEFDESC=\”FACTORY DEFAULTS\””
;
Step 5
Issue the COPY-RFILE command. This command will initiate the download process. See the
“2.6.1 COPY-RFILE” section on page 2-43 for command syntax.
In the following example the package is located in “/%2FUSR/CET/VINTARA” in the host
10.77.22.199. The userid and passwords are TL1 and CISCO454. The directory path of the package is
similar to what you will see during an FTP session.
Example 2-35 COPY-RFILE::RFILE-
PKG:CTAG::TYPE=SWDL,SRC=”FTP://TL1:CISCO454@10.77.29.199
/%2FUSR/CET/VINTARA/15454-0340-X02E-2804.PKG”;
DEV208 1970-01-10 11:51:57
M CTAG COMPLD
;
Step 6
If any of the parameters are wrong or if the host is not accessible, a REPT EVT FXFR message will
report from the following list. A download failure can result from one or more of the following:
• Directory path of the package is invalid or not found
• Package is invalid (for example, an ONS 15454 package on an ONS 15327, vice-versa, or an invalid
file type)
• Package not found on specified path
• Userid/password or hostname is invalid
• Host is not accessible
• Firewall userid/password or host in invalid
• Node rebooted/lost connection during download
• If software download is already in progress
• If the node or the host timed out during FTP protocol
To Next Page
Loading...
