2-47
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.6.4 Downloading New Software
Example 2-36 DEV208 1970-01-10 11:52:02
A 2816.2816 REPT EVT EQPT
“SLOT-11:SFTWDOWN-FAIL,TC,,,,,,,:\”SOFTWARE DOWNLOAD FAILED\”,TCC
;
Step 7
If the download is successful the REPT EVT FXFR message will report an active start:
Example 2-37 DEV208 1970-01-10 11:52:15
A 2818,2818 REPT EVT FXFR
“ACTIVE START”
;
Step 8
A SFTDOWN minor alarm is raised to indicate that the software download is in progress. The
SFTDOWN alarm will clear when the download is complete.
Example 2-38 DEV208 1970-01--10 11:52:15
* 2817.2817 REPT ALM EQPT
“SLOT-7:MN,SFTWDOWN,NSA,,,,:\”SOFTWARE DOWNLOAD IN PROGRESS\”,TCC”
;
Use the in-progress status at any time during the software download to verify the RTRV-NE-GEN
command.
Example 2-39 RTRV-NE-GEN
VA454-94 1970-01-06 22:22;12
M 1 COMPLD
“IPADDR=10.82.87.94,IPMASK=255.255.255.224,DEFRTR=10.82.86.1,
ETHIPADDR=10.82.87.94,EHTIPMASK=255.255.255.224,NAME=VA454-94,
SWVER=3.40.00,LOAD=03.40-002G-14-21,PROTSWVER=NONE,
PROTLOAD=DOWNLOADINPROGRESS,DEFDESC=\:FACTORY DEFAULTS\””
;
Step 9
The download progress is reported by the REPT EVT FXFR message which will report a message after
every 20% of download is complete as shown:
Example 2-40 DEV208 1970-01-10 11:53:12
A 2820,2820 REPT EVT FXFR
“ACTIVE,IP,,20”
;
DEV208 1970-01-10 11:53:12
A 2820,2820 REPT EVT FXFR
“ACTIVE,IP,,40”
;
DEV208 1970-01-10 11:53:12
A 2820,2820 REPT EVT FXFR
“ACTIVE,IP,,60”
;
DEV208 1970-01-10 11:53:12