3-2
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 3 TL1 Errors
3.1 Errors
Equipment Not Present
Equipment Not Provisioned
IP Address Not Found
IP Mask Not Found
Internal Communication Error
Next Hop Not Found
No standby present
No standby provisioned
Not Equipped
Sensor IF Is Not Found
Sensor Interface Not Found
Standby not in valid state, please wait
TID Not Found
Table 3-2 IBEX Errors
IBEX Error Messages
Extra Datablock
Extra parameters
Invalid AID Block. Extra Datablock
Invalid Payload Block. Extra Datablock
Table 3-3 ICNV Errors
ICNV Error Messages
Admin SSM Not Supported
Cannot Set DCC When G709 Is Enabled
Cross Connect Not Supported By XC Mode
Equipment Does Not Match Request
Equipment In Use
Inhfelpbk Not Supported
Invalid Command
Operation Not Supported By This Card
PDIP Not Supported
PM Threshold Type Not Supported
PM Type Not Supported
Payload Does Not Match Request
Table 3-1 ENEQ Errors (continued)
ENEQ Error Messages
To Next Page
Loading...
