Cisco ONS 15454 - 1-Way Circuit Single Roll and Dual Roll Procedures; Create a 1-Way Circuit Single Roll

2-56
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.8.4 1-Way Circuit Single Roll and Dual Roll Procedures
Step 2 If you performed a manual roll, you must confirm the circuit is valid by issuing the
RTRV-BULKROLL-<OCN_TYPE> command:
Input Format:
RTRV-BULKROLL-<OCN_TYPE>:[<TID>]:<SRC>:<CTAG>;
Input Example:
RTRV-BULKROLL-OC12:CISCO:FAC-3-1:1;
2.8.4 1-Way Circuit Single Roll and Dual Roll Procedures
Single roll operation moves either the source or destination of a circuit to a new endpoint:
• Onto the same node or
• Onto a different node
In single roll operation you only choose one roll point during the process.
Dual roll operation reroutes a segment between two roll points of a circuit. The new route can be:
• Anew link (no circuit is required), or
• Another circuit (created before or during the bridge and roll process.
• In dual roll operation, you choose two roll points during the process.
2.8.4.1 Create a 1-Way Circuit Single Roll
To create a 1-way circuit single roll, enter the ENT-ROLL-<MOD_PATH> command or the
ENT-BULKROLL-<OCN_TYPE> command depending on the type of roll you want to perform.
Input Formats:
• ENT-ROLL-<MOD_PATH>:[<TID>]:<FROM>,<TO>:<CTAG>:::RFROM=<RFROM>,
RTO=<RTO>,RMODE=<RMODE>,[CMDMDE=<CMDMDE>];
Note For a 1-way destination roll, the roll mode must be manual (MAN).
• ENT-BULKROLL-<OCN_TYPE>:[<TID>]:<FROM>:<CTAG>:::RTOSTART=<RTOSTART>,
[RFROMSTART=<RFROMSTART>],[RFROMEND=<RFROMEND>],RMODE=<RMODE>,
[CMDMDE=<CMDMDE>];
VT#2 on STS#3 VT1-5-1-3-2-4 VT1-6-1-3-2-4
STS#4 STS-5-1-4 STS-6-1-4
Table 2-7 2-Way Circuit Single or Dual Bulk Roll with ENT-BULKROLL (continued)
Paths Before Roll After Roll