Cisco ONS 15454 - 1.2 Troubleshooting Electrical Circuit Paths With Loopbacks

2-13
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.2.7 Delete Test Access Points
The command in Example 2-11 disconnects TAP 1 from the circuit/cross-connect under test.
Example 2-11 DISC-TACC::1:12;
DV9-99 1970-01-02 02:59:43
M 12 COMPLD
;
Note This command generates a REPT DBCHG message.
Error codes supported:
SADC—Already disconnected
SRTN—Unable to release TAP
2.2.7 Delete Test Access Points
The command in Example 2-12 deletes a TAP.
Example 2-12 ED-<STS_PATH>:[<[TID>]:<AID>:<CTAG>:::TACC=0:;
Note The TACC number must be set to zero in order to delete a TAP.
Note If a TAP is not removed the STS bandwidth will be stranded.
2.2.8 Test Access Configurations
Figure 2-3 Single Node View (Node 1)
RTU
E
F
Test Set
71716