Cisco ONS 15454 - OC-N Payload Provisioning Parameters

2-70
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.12.3 OC-N Payload Provisioning Parameters
4. Changing payload while in a regeneration group requires first unprovisioning the regeneration
group, unprovisioning the payload, reprovisioning the payload, and reprovisioning the regeneration
group.
The TL1 commands are:
• ENT/DLT/ED-(OCn, nGIGE, nGFC, 2R)
Examples of provisioning payload:
ENT-OC12
ENT-10GIGE
ED-2GFC
• ENT/DLT/ED-EQPT
Example of setting termination mode:
ENT-EQPT::SLOT-1:116::TXP-MR-10E:CARDMODE=DWDM-TRANS-AIS;
2.12.3 OC-N Payload Provisioning Parameters
SONET payloads are supported by DWDM cards according to Table 2-18. These payloads are
configurable only for the Section and Line layers. STS layers cannot be provisioned or retrieved.
Table 2-18 Payload/Card Mode Support
Card Type Payload Card Mode
TXP_MR_10G OC192 DWDM-LINE
10GIGE DWDM-SECTION
DWDM-TRANS-AIS
DWDM-TRANS-AIS with REGEN group
OC192, 10GIGE Does not support PPM. Card mode not
applicable.
MXP_2.5G_10G OC48 DWDM-LINE
DWDM-SECTION
DWDM-TRANS-AIS
TXP_MR_2.5G and
TXPP_MR_2.5G
1GIGE, 1GF, 1GFICON,
2GFICON, ESCON, ISC1,
ISC3, ETRCLO, DV6000,
HDTV, D1VIDEO
DWDM-TRANS-AIS with REGEN group.
Must be DWDM-TRANS-AIS. Requires
the DWRAP and FEC disabled on the
network/OCH ports.
OC3, OC12, OC48 DWDM-LINE, DWDM-SECTION,
DWDM-TRANS-AIS
TXP_MR_10E OC192 DWDM-LINE, DWDM-SECTION,
DWDM-TRANS-AIS,
DWDM-TRANS-SSQUELCH
10GIGE, 10GFC DWDM-TRANS-AIS,
DWDM-TRANS-SQUELCH,
With REGEN group it must be
DWDM-TRANS-AIS,
DWDM-TRANS-SQUELCH