Cisco ONS 15454 - Port State Model Provisioning Rules; SONET-Related Provisioning Rules

2-79
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.12.17 Port State Model Provisioning Rules
• ED-ALS- (OCn, nGIGE, nGFC, OTS, OMS, OCH)
Example of editing ALS attributes:
ED-ALS-OC192::FAC-1-1-1:100:::ALSMODE=Y,ALSRCINT=130,
ALSRCPW=35.1,RLASER=Y:
2.12.17 Port State Model Provisioning Rules
1. The enhanced state model port state of primary state=OOS and secondary state=AINS is not
supported for the 1GigE/2GigE payload type.
2. The working and protect ports can be put in IS/OOS independently.
3. For the protect TXP card:
a. Setting the protect trunk port to OOS enables the suppression of alarms on that port and will
enable the card to be used like an unprotected card, but the card still cannot be used for a Y-cable
protection group.
b. Setting the protect trunk port to OOS will not switch off the transmit laser unless both trunk
ports are OOS.
c. The protect trunk port cannot be IS if there is a loopback or a regeneration group provisioned.
The TL1 commands are:
• ED-(OCn, nGIGE, nGFC, OCH)
Example of editing Port State:
ED-OC48::FAC-6-1-1:114::::OOS,AINS;
ED-10GIGE::FAC-6-1:114::::OOS,AINS;
ED-OCH::CHAN-6-1:114::::IS;
2.12.18 SONET-Related Provisioning Rules
1. The SD/SFBER can only be provisioned on the working trunk port (OCH) for the protect TXP card.
Values set at the working port will be reflected on the trunk port.
The TL1 commands are:
• ED-OCH
Example of editing trunk port attributes:
ED-OCH::CHAN-6-2:114:::RDIRN=W-E,EXPWLEN=1530.32,VOAATTN=2.5,
VOAPWR=7.5,CALOPWR=0,CHPOWER=2.0,NAME=“NYLINE”,SFBER=1E-5,
SDBER=1E-6,ALSMODE=MAN,ALSRCINT=60,ALSRCPW=35.1,COMM=DCC,
GCCRATE=192K,OSDBER=1E-6,DWRAP=Y,FEC=Y,
MACADDR=OO-OE-AA-BB-CC-DD,SYNCMSG=N,SENDDUS=Y,
RLASER=Y,SOAK=10,OSPF=Y:OOS,AINS;