Cisco ONS 15454 - SOSE Errors; SPFA Errors; SPLD Errors; Table

3-29
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 3 TL1 Errors
3.1 Errors
No Switch In Progress
No Valid Roll Signal
No loopback in progress
Protection Group Does Not Exist
Protection Unit Active
Provisioning Not Allowed On Protecting Card
Roll Condition Does Not Exist
Roll is not controlled by TL1
Status, Not in Valid State
Unable To Complete Roll
VCG Already Created
Working Unit Already Active
Working Unit Already Standby
Table 3-53 SOSE Errors
SOSE Error Messages
Unrecognized Message Type
Table 3-54 SPFA Errors
SPFA Error Messages
Cannot Get Current Card Status
Protection Unit Failed Or Missing
Status, Protection Unit Failed or Missing
Table 3-55 SPLD Errors
SPLD Error Messages
Cannot Create 1+1 Protection Group
Cannot Delete Equipment
Equipment In Use
FTP Task Is Busy
Facility Is Busy
Protection Unit Locked
Table 3-52 SNVS Errors (continued)
SNVS Error Messages