3-27
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 3 TL1 Errors
3.1 Errors
Table 3-46 SDNA Errors
SDNA Error Messages
Active TCC Not Ready
Standby TCC Not Ready
Table 3-47 SNCC Errors
SNCC Error Messages
Cross connection does not exist
Path Roll Does Not Exist
Replace This Message When A SNCC message is needed
Table 3-48 SNCN Errors
SNCN Error Messages
Bad Quality
Cannot Switch To Bad Reference
Cannot Switch To Inferior Reference Source
Command Not Implemented
Cross-Connection Type Not Supported In TL1
Invalid Clock Source
Requested Direction Not Supported
STS Rate Change Not Supported
Sync Switch Operation Failed, Reference In OOS
Table 3-49 SNNS Errors
SNNS Error Messages
Reference Not From Optical Card
Table 3-50 SNOS Errors
SNOS Error Messages
Cannot Change Card Wavelength With Port(s) Not In OOS,DSBLD State
Cannot Change Payload With Port(s) Not In OOS State
Cannot Change Payload With Port(s) Not In OOS-MA,DSBLD State
Cannot Change Termination Mode With Port(s) Not In OOS State
To Next Page
Loading...
