CHAPTER
2-1
Cisco ONS SONET TL1 Command Guide, R6.0
2
Procedures and Provisioning
Note The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter provides TL1 procedures and provisioning for the Cisco ONS 15454, ONS 15327,
ONS 15310-CL and ONS 15600.
• 2.1 Setting up TL1 Communication, page 2-1
• 2.2 Test Access, page 2-5
• 2.3 TL1 Gateway, page 2-25
• 2.4 Ring Provisioning, page 2-31
• 2.5 PCA Provisioning, page 2-41
• 2.6 FTP Software Download, page 2-43
• 2.7 Scheduled PM Report, page 2-50
• 2.8 Bridge and Roll, page 2-51
• 2.9 1:N Low-Density to 1:N High-Density Upgrade, page 2-59
• 2.10 Remote Monitoring-Managed PMs, page 2-60
• 2.11 Rules for Framing Type Autoprovisioning in CTC Versus TL1, page 2-68
• 2.12 Provisioning Rules for Transponder and Muxponder Cards, page 2-69
2.1 Setting up TL1 Communication
The period during which a user is logged into the node is called a session. There are three options you
can use to open a session (login):
• Cisco Transport Controller (CTC)
• Telnet
• Craft interface
To Next Page
Loading...
