Cisco ONS 15454 - Document Objectives; Audience; Related Documentation

1-12
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 1 General Information
1.8.6 Ports
1.8.6 Ports
1.8.7 SONET Line Protection
Table 1-10 Ports Default Values
Ports Default
OC-N Line DCC defaults to N
TMGREF defaults to N
SYNCMSG defaults to Y
SENDDUS defaults to N
PJMON defaults to 0
SFBER defaults to 1E-4
SDBER defaults to 1E-7
MODE defaults to SONET
PST defaults to OOS
EC1 Line PJMON defaults to 0 (zero)
LBO defaults to 0-225
RXEQUAL is Y
PST defaults to defaults to OOS
T1 Line (DS1/DS1N) LINECDE defaults to AMI
FMT defaults to D4
LBO defaults to 0-133
PST defaults to OOS
T3 Line (DS3, DS3E, DS3NE,
DS3XM)
DS3/T3 LINECDE defaults to 0-225
DS3 PST defaults to OOS
DS3E/DS3NE FMT defaults to UNFRAMED
DS3E/DS3NE LINECDE defaults to B3ZS
DS3E/DS3NE LBO defaults to 0-225
DS3 of DS3XM PST defaults to OOS
Table 1-11 SONET Line Protection Default Values
SONET Line Protection Default
EX-SW-<OCN> ST (switch type) is optional and for BLSR protection switch only
ST defaults to BLSR RING switch type
OC-N Line Protection PROTID defaults to the protecting port of the protection group
(SLOT-#(OCN)PORT-#). It is a string that can have a maximum length of
32 characters
RVRTV defaults to N (non-revertive mode)
RVTM defaults to 5.0 minutes
PSDIRN defaults to UNI
OPR-PROTNSW-<OCN> ST (switch type) is optional and for BLSR protection switch only
ST defaults to BLSR RING switch type