Cisco ONS 15454 - Activating New Software; Activate New Software

2-48
Cisco ONS SONET TL1 Command Guide, R6.0
Chapter 2 Procedures and Provisioning
2.6.5 Activating New Software
A 2820,2820 REPT EVT FXFR
“ACTIVE,IP,,80”
;
Step 10 If the TL1 session times out during download or if the user terminates the TL1 session the download will
continue. The download completion can be confirmed by issuing the RTRV-NE-GEN command and
verifying the PROTLOAD.
Example 2-41 RTRV-NE-GEN:::1;
VA454-94 1970-01-06 22:22:12
M 1 COMPLD
“IPADDR=10.82.87.94,IPMASK=255.255.255.224,DEFRTR=10.82.86.1,
ETHIPADDR=10.82.87.94,EHTIPMASK=255.255.254.0,NAME=VA454-94,
SWVER=3.40.00,LOAD=03.40-002G-14-21,PROTSWVER=4.00.00,
PROTLOAD=03.40-X02E-28.04,DEFDESC=\:FACTORY DEFAULTS\””
;
Step 11 REPT EVT FXFR confirms the completion of the software download.
Example 2-42 DEV208 1970-01-10 12:01:16
A 2825,2825 REPT EVT FXFR
“ACTIVE,COMPLD,SUCCESS”
;
Step 12 The SFTDOWN alarm clears when the download is complete.
Example 2-43 DEV208 1970-01-10 11:52:15
* 2826,2817 REPT ALM EQPT
“SLOT-7:CL,SFTWDOWN,NSA,,,,:\”SOFTWARE DOWNLOAD IN PROGRESS\”,TCC”
;
2.6.5 Activating New Software
After the software is successfully downloaded, the new software which resides in the protect load must
be activated to run on the NE. The APPLY command can be used to activate and revert depending on the
version of the protect software and the newly downloaded software (see the “2.6.2 APPLY” section on
page 2-44 for correct APPLY syntax).
Activate New Software
Step 1 If the protect software is newer than the working software, activate it as shown:
Example 2-44 APPLY::1::ACT;
DEV208 1970-01-10 13:40:53
M 1 COMPLD
;
An error is reported if a revert is attempted with a newer protect software.