Smartports
Macro Failure and the Reset Operation
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 107
9
Two Smartport macros are paired by their names as follows:
• macro_name (for example: printer)
• no_macro_name (for example: no_printer, the anti Smartport macro of
Smartport macro printer)
See the Built-in Smartport Macros section for a listing of the built-in Smartport
macros for each device type.
Applying a Smartport Type to an Interface
When Smartport types are applied to interfaces, the smartport types and
configuration in the associated Smartport macros are saved in the Running
Configuration File. If the administrator saves the Running Configuration File into the
Startup Configuration File, the switch will apply the Smartport types and the
Smartport macros to the interfaces after reboot as follows:
• If the Startup Configuration File does not specify a Smartport type for an
interface, its Smartport type is set to Default.
• If the Startup Configuration File specifies a static Smartport type, the
Smartport type of the interface is set to this static type.
• If the Startup Configuration File specifies a Smartport type that was
dynamically assigned by Auto Smartport:
- If the Auto Smartport Global Operational state, the interface Auto
Smartport state, and the Persistent Status are all Enable, the Smartport
type is set to this dynamic type.
- Else the corresponding anti-macro is applied and the interfaces status is
set to Default.
Macro Failure and the Reset Operation
A Smartport macro may fail if there is a conflict between the existing configuration
of the interface and a Smartport macro.
When a Smartport macro fails, a SYSLOG message containing the following
parameters is sent:
To Next Page
Loading...
Need help?
General
