Configuring Multicast Forwarding
Adding IP Multicast Group Addresses
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 200
15
• Static—Attaches the interface to the Multicast group as a static member.
• Dynamic—Indicates that the interface was added to the Multicast group as
a result of IGMP/MLD snooping.
• Forbidden—Specifies that this port is not allowed to join this group on this
VLAN.
• None—Specifies that the port is not currently a member of this Multicast
group on this VLAN.
STEP 10 Click Apply, and the Running Configuration file is updated.
NOTE Entries that were created in the
IP Multicast Group Address
page
cannot be deleted in this page (even if they are selected).
Adding IP Multicast Group Addresses
The
IP Multicast Group Address
page
is similar to the
MAC Group Address
page
except that Multicast groups are identified by IP addresses.
The
IP Multicast Group Address
page enables querying and adding IP Multicast
groups.
To define and view IP Multicast groups:
STEP 1 Click Multicast> IP Multicast Group Address. The
IP Multicast Group Address
page
opens.
The page displays all of the IP Multicast group addresses learned by snooping.
STEP 2 Enter the parameters required for filtering.
• VLAN ID equals to—Define the VLAN ID of the group to be displayed.
• IP Version equals to—Select IPv6 or IPv4.
• IP Multicast Group Address equals to—Define the IP address of the
Multicast group to be displayed. This is only relevant when the Forwarding
mode is (S,G).
To Next Page
Loading...
Need help?
General
