Configuring Quality of Service
Managing QoS Statistics
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 264
18
STEP 3 Select a Port/LAG, and click Edit. The Edit Egress Shaping Per Queue page
opens.
This page enables shaping the egress for up to four queues on each interface.
STEP 4 Select the Interface.
STEP 5 For each queue that is required, enter the following fields:
• Enable Shaping—Select to enable egress shaping on this queue
.
• Committed Information Rate (CIR)—Enter the maximum rate (CIR) in Kbits
per second (Kbps). CIR is the average maximum amount of data that can be
sent.
• Committed Burst Size (CBS)—Enter the maximum burst size (CBS) in bytes.
CBS is the maximum burst of data allowed to be sent even if a burst exceeds
CIR.
STEP 6 Click Apply. The bandwidth settings are modified, and the Running Configuration
file is updated.
Workflow to Configure Basic QoS Mode
Managing QoS Statistics
From this page you can manage the Single Policer, Aggregated Policer, and view
queues statistics.
Viewing Policer Statistics
A Single Policer is bound to a class map from a single policy. An Aggregate Policer
is bound to one or more class maps from one or more policies.
To Next Page
Loading...
