VLAN Management
Creating VLANs
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 162
12
To change the default VLAN:
STEP 1 Click VLAN Management > Default VLAN Settings. The
Default VLAN Settings
page opens.
STEP 2 Enter the value for the following field:
• Current Default VLAN ID—Displays the current default VLAN ID.
• Default VLAN ID After Reboot—Enter a new VLAN ID to replace the default
VLAN ID after reboot.
STEP 3 Click Apply.
STEP 4 Click Save (in the upper-right corner of the window) and save the Running
Configuration to the Startup Configuration.
The Default VLAN ID After Reset becomes the Current Default VLAN ID after
you reboot the switch.
Creating VLANs
You can create a VLAN, but this has no effect until the VLAN is attached to at least
one port, either manually or dynamically. Ports must always belong to one or more
VLANs.
The Cisco Sx200 Series switch supports 128 VLANs, including the default VLAN.
Each VLAN must be configured with a unique VID (VLAN ID) with a value from
1 to 4094. The switch reserves VID 4095 as the Discard VLAN. All packets
classified to the Discard VLAN are discarded at ingress, and are not forwarded to
a port.
To Next Page
Loading...
