Managing System Logs
Viewing Memory Logs
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 19
3
• Log Server IP Address/Name—Enter the IP address or domain name of the
log server.
• UDP Port—Enter the UDP port to which the log messages are sent.
• Facility—Select a facility value from which system logs are sent to the
remote server. Only one facility value can be assigned to a server. If a second
facility code is assigned, the first facility value is overridden.
• Description—Enter a server description.
• Minimum Severity—Select the minimum level of system log messages to
be sent to the server.
STEP 4 Click Apply. The Add Remote Log Server page
closes, the SYSLOG server is
added, and the Running Configuration file is updated.
Viewing Memory Logs
The switch can write to the following logs:
• Log in RAM (cleared during reboot).
• Log in Flash memory (cleared only upon user command).
You can configure the messages that are written to each log by severity, and a
message can go to more than one log, including logs that reside on external
SYSLOG servers.
RAM Memory
RAM Memory
The RAM Memory page
displays all messages, in chronological order, that were
saved in RAM (cache). Entries are stored in the RAM log according to the
configuration in the Log Settings page.
To Next Page
Loading...
Need help?
General
