Cisco SF200-24 - Multiple Devices Attached to the Port

Smartports
Auto Smartport
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 111
9
NOTE If only the IP Phone and Host bits are set, then the SmartPort type is
ip_phone_desktop.
Multiple Devices Attached to the Port
The switch derives the SmartPort type of a connected device via the capabilities
the device advertises in its CDP and/or LLDP packets.
Two-Port MAC Relay 0x400 Ignore
Table 3 LLDP Capabilities Mapping to Smartport Type
Capability Name
LLDP Bit Smartport Type
Other 1 Ignore
Repeater IETF RFC 2108 2 Ignore
MAC Bridge IEEE Std 802.1D 3 Switch
WLAN Access Point IEEE Std 802.11
MIB
4 Wireless Access
Point
Router IETF RFC 1812 5 Router
Telephone IETF RFC 4293 6 ip_phone
DOCSIS cable device IETF RFC 4639
and IETF RFC 4546
7Ignore
Station Only IETF RFC 4293 8 Host
C-VLAN Component of a VLAN Bridge
IEEE Std 802.1Q
9Switch
S-VLAN Component of a VLAN Bridge
IEEE Std 802.1Q
10 Switch
Two-port MAC Relay (TPMR) IEEE Std
802.1Q
11 Ignore
Reserved 12-16 Ignore
Table 2 CDP Capabilities Mapping to Smartport Type (Continued)
Capability Name CDP Bit Smartport Type