Configuring IP Information
Management and IP Interfaces
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 218
16
Defining an IPv6 Default Router List
The IPv6 Default Router List page enables configuring and viewing the default
IPv6 router addresses. This list contains the routers that are candidates to become
the switch default router for non-local traffic (it may be empty). The switch
randomly selects a router from the list. The switch supports one static IPv6 default
router. Dynamic default routers are routers that have sent router advertisements to
the switch IPv6 interface.
When adding or deleting IP addresses, the following events occur:
• When removing an IP interface, all the default router IP addresses are
removed.
• Dynamic IP addresses cannot be removed.
• An alert message is displayed after an attempt is made to insert more than
a single user-defined address.
• An alert message is displayed when attempting to insert a non-link local
type address, meaning 'fe80:'.
To define a default router:
STEP 1 Click Administration > Management Interface (Layer 2) > IPv6 Default Router
List.
The IPv6 Default Router List page opens.
This page displays the following fields for each default router:
• Default Router IPv6 Address—Link local IP address of the default router.
• Interface—Outgoing IPv6 interface where the default router resides.
• Type—The default router configuration that includes the following options:
- Static—The default router was manually added to this table through the
Add button.
- Dynamic—The default router was dynamically configured.
State—The default router status options are:
- Incomplete—Address resolution is in process. Default router has not yet
responded.
- Reachable—Positive confirmation was received within the
Reachable
Time.
To Next Page
Loading...
Need help?
General
