Configuring IP Information
Domain Name Systems
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 228
16
STEP 2 To add a host mapping, click Add. The Add Host Mapping page opens.
STEP 3 Enter the parameters.
• IP Version—Select Version 6 for IPv6 or Version 4 for IPv4.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select whether
it is received through VLAN2 or ISATAP.
• Host Name—Enter a domain name, up to 158 characters.
• IP Address—Enter an IPv4 address or enter up to four IPv6 host addresses.
Addresses 2–4 are backup addresses.
STEP 4 Click Apply. The DNS host is added, and the Running Configuration file is updated.
To Next Page
Loading...
