Cisco SF200-24 User Manual

Configuring Security
Defining Access Profiles
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 240
17
- HTTP—Assigns HTTP access to the rule. Users requesting access to the
switch who meet the HTTP access profile criteria, are permitted or
denied.
- Secure HTTP (HTTPS)—Users requesting access to the switch who
meet the HTTPS access profile criteria, are permitted or denied.
• Action—Select Permit to permit the users that attempt to access the switch
by using the configured access method from the interface and IP source
defined in this rule. Or select Deny to deny access.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies only to the port, VLAN, or LAG selected.
• Interface—Enter the interface number.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. The Source IP Address field is valid for a
subnetwork. Select one of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in
the fields.
• IP Version—Select the supported IP version of the source address: IPv6 or
IPv4.
• IP Address—Enter the source IP address.
• Mask—Select the format for the subnet mask for the source IP address, and
enter a value in one of the field:
- Network Mask—Select the subnet to which the source IP address
belongs and enter the subnet mask in dotted decimal format.
- Prefix Length—Select the Prefix Length and enter the number of bits that
comprise the source IP address prefix.
STEP 5 Click Apply, and the rule is added to the access profile.

Cisco SF200-24 Specifications

General

Brand	Cisco
Model	SF200-24
Category	Switch
Language	English