Cisco SF200-24 User Manual

System Time
Configuring System Time
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 38
5
- European —DST will be set according to the dates used by the European
Union and other countries that use this standard.
-
By Dates —DST will be set manually, typically for a country other than the
USA or a European country. Enter the following parameters:
-
Recurring —DST occurs on the same date every year. Enter the following
parameters:
Selecting
By Dates allows customization of the start and stop of DST:
• From—Day and time that DST starts.
• To—Day and time that DST ends.
Selecting
Recurring allows further customization of the start and stop of
DST:
• From—Date when DST begins each year.
-
Day —Day of the week on which DST begins every year.
-
Week —Week within the month from which DST begins every year.
-
Month —Month of the year in which DST begins every year.
-
Time —The time at which DST begins every year.
• To—Date when DST ends each year. For example, DST ends locally every
fourth Friday in October at 5:00 am. The parameters are:
-
Day —Day of the week on which DST ends every year.
-
Week —Week within the month from which DST ends every year.
-
Month —Month of the year in which DST ends every year.
-
Time —The time at which DST ends every year.
STEP 3 Click Apply. The system time values are defined, and the Running Configuration
file is updated.
The time settings are displayed in the Actual Time Details block.

Cisco SF200-24 Specifications

General

Model	SF200-24
Switching Capacity	8.8 Gbps
Layer	Layer 2
Form Factor	Rack-mountable
Power Supply	Internal
MAC Address Table Size	8000 entries
Switch Type	Managed
Power over Ethernet (PoE)	No
Stackable	No
Jumbo Frame Support	9216 bytes
VLAN Support	Yes
Quality of Service (QoS)	4 hardware queues
Ports	24