Configuring Discovery
Configuring CDP
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 82
7
• Time to Live (sec)—Time interval (in seconds) after which the information for
this neighbor is deleted.
• Capabilities—Capabilities advertised by neighbor.
• Platform—Information from Platform TLV of neighbor.
• Neighbor Interface—Outgoing interface of the neighbor.
STEP 2 Select a device, and click Details. The
CDP Neighbors Details
page opens.
This page displays the following fields about the neighbor:
• Device ID—Identifier of the neighboring device ID.
• Local Interface—Interface number of port through which frame arrived.
• Advertisement Version—Version of CDP.
• Time to Live—Time interval (in seconds) after which the information for this
neighbor is deleted.
• Capabilities—Primary functions of the device. The capabilities are indicated
by two octets. Bits 0 through 7 indicate Other, Repeater, Bridge, WLAN AP,
Router, Telephone, DOCSIS cable device, and station respectively. Bits 8
through 15 are reserved.
• Platform—Identifier of the neighbor’s platform.
• Neighbor Interface—Interface number of the neighbor through which frame
arrived.
• Native VLAN—Neighbor’s native VLAN.
• Duplex—Whether neighbors interface is half or full duplex.
• Addresses—Neighbor’s addresses.
• Power Drawn—Amount of power consumed by neighbor on the interface.
• Version—Neighbor’s software version.
NOTE Clicking on the Clear Table button will disconnect all connected devices if from
CDP, and if Auto Smartport is enabled will change all port types to default.
To Next Page
Loading...
Need help?
General
