Cisco SGE2000

112
Chapter 6: Configuring VLANs
Configuring GVRP Settings
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
6
• Interface — Displays the interface on which GVRP is enabled.
• GVRP State — Indicates if GVRP is enabled on the interface. The possible field values are:
– Enabled — Enables GVRP on the selected interface.
– Disabled — Disables GVRP on the selected interface.
• Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on the interface. The
possible field values are:
– Enable — Enables Dynamic VLAN creation on the interface.
– Disable — Disables Dynamic VLAN creation on the interface.
• GVRP Registration — Indicates if VLAN registration through GVRP is enabled on the device. The
possible field values are:
– Enable — Enables GVRP registration on the device.
– Disable — Disables GVRP registration on the device.
2. Define the relevant fields.
3. Click Apply. The GVRP Settings are defined, and the device is updated.
Modifying GVRP Settings
1. Click Bridging > VLAN Management > GVRP Settings. The GVRP Settings Page opens:
2. Click the Edit button. The Edit GVRP Page opens:
Edit GVRP Page
The Edit GVRP Page contains the following fields:
• Interface — Displays the interface on which GVRP is enabled. The possible field values are:
– Port — Indicates the port number on which GVRP is enabled.
– LAG — Indicates the LAG number on which GVRP is enabled.
• GVRP State — Indicates if GVRP is enabled on the interface. The possible field values are: