213
Chapter 12: Configuring Quality of Service
Defining Advanced Mode
SGE2000/SGE2000P Gigabit Ethernet Switch Reference Guide
Chapter
12
Modifying QoS Aggregate Policer
1. Click Quality of Service > Advanced > Aggregate Policer. The Aggregate Policer Page opens:
2. Click the Edit Button. The Edit QoS Aggregate Policer Page opens:
Edit QoS Aggregate Policer Page
The Edit QoS Aggregate Policer Page contains the following fields.
• Aggregate Policer Name— Specifies the Aggregate Policer Name
• Ingress Committed Information Rate (CIR) — Defines the CIR in bits per second. This field is
only relevant when the Police value is Single.
• Ingress Committed Burst Size (CBS) — Defines the CBS in bytes per second. This field is only
relevant when the Police value is Single.
• Exceed Action — Action assigned to incoming packets exceeding the CIR. This field is only
relevant when the Police value is Single. Possible values are:
– Drop — Drops packets exceeding the defined CIR value.
– Remark DSCP —Remarks packet’s DSCP values exceeding the defined CIR value.
– None —Forwards packets exceeding the defined CIR value.
3. Modify the relevant fields.
4. Click Apply. QoS aggregate policer settings are modified, and the device is updated.
To Next Page
Loading...
Need help?
General
