UNITY INSTALLATION GUIDE
120
Dialogic D/41E PCI
Continued
voice board
Hardware settings
Do the following procedures as you install voice boards.
To set the SW1 switch
For each Dialogic PCI voice board that has a rotary switch,
set the rotary switch to a unique value starting with 1 and
continuing in sequence.
For example, set the rotary switch on the first three PCI
voice boards in the Unity server as shown below. This is also
the order in which you install the boards in the server.
To set switch block SW2
Set SW2 switches to “Off” on all boards.
To set jumpers JP2 to JP7
Set jumpers JP2 to JP5 to “Off” on each board. For jumpers
JP6 and JP7, install shunts on the top two pins (1 and 2).
Software settings
None.
First PCI board
Second PCI board
Third PCI board
JP2 JP3 JP4 JP5 JP6 JP7
Setting
1
2
3
To Next Page
Loading...
