UNITY INSTALLATION GUIDE
100
Upgrading a
Unity or
ActiveFax
server
This section contains procedures that you do if you are:
◆
Upgrading Unity and ActiveFax software on the Unity server
from version 2.3 to version 2.4
◆
Moving ActiveFax from the Unity server to a separate fax
server.
◆
Adding or changing voice boards in the Unity server.
◆
Adding or changing fax boards in the Unity or ActiveFax
server.
Do the procedures that apply to your situation, and do them in
the order listed.
Included in this section are procedures to remove different
brands of voice board software. Do the procedure(s) that apply to
your voice board brand(s).
CAUTION: You must uninstall voice board software before you
upgrade to Unity 2.4, or the upgrade will fail.
If you only want to add or remove languages after you have
upgraded to Unity version 2.4, see “Adding or removing lan-
guages,” on page 111.
Backing up the Unity server
Back up the Unity server in case the upgrade process fails and
you need to restore the Unity server to its original state. Use
whatever process you normally use to back up the entire con-
tents of the Unity server.
Removing Dialogic voice board software
Do the following two procedures if the Unity server contains Dia-
logic voice boards, and if you are:
◆
Upgrading Unity software to version 2.4.
◆
Adding or changing voice boards, even if you are adding
boards of the same type.
To Next Page
Loading...
Need help?
General
