CHAPTER 3:
Installing a Unity system
75
Setting up
fax ports for
ActiveFax
If you installed ActiveFax, run the FAX Monitor program to:
◆
Set whether a fax port sends faxes, receives faxes, or both
sends and receives faxes.
◆
Enter settings for routing inbound faxes.
The FAX Monitor contains information about the fax ports on the
server that ActiveFax is installed on; the information was auto-
matically detected during the ActiveFax installation. The infor-
mation is displayed in the FAX Monitor window, shown below,
and in its Setup dialog box.
Each square at the bottom of the FAX Monitor window repre-
sents a fax port. Colored squares indicate fax ports that are
available for use with ActiveFax.
The number of fax ports available to ActiveFax is specified on the
Unity system key (or on the ActiveFax system key if ActiveFax is
on a separate server). If the number on the key is less than the
total number of fax ports on the installed fax boards, ActiveFax
disables the extra ports. A red “X” in a FAX Monitor square
means that ActiveFax has disabled the corresponding fax port.
Continued
DO THIS SECTION?
TURNKEY
SYSTEM
YES NO
see
page
Voice mail only 80
Voice mail with LAN admin
✓
Unified, one Exchange server
✓
Unified, existing Exchange site
✓
COMPONENT
SYSTEM
Voice mail only 80
Voice mail with LAN admin
✓
Unified, one Exchange server
✓
Unified, existing Exchange site
✓
ACTIVEFAX SERVER
✓
To Next Page
Loading...
Need help?
General
