Cisco Unity - Setting up Fax Ports for Activefax

UNITY INSTALLATION GUIDE
76
Setting up fax ports
Continued
for ActiveFax
To display the Setup dialog box
The Setup dialog box can be displayed only when the LFdriver, a
component of ActiveFax, is not running. (The LFdriver provides
the interface between the fax boards and ActiveFax.) The
LFdriver starts automatically when the server that ActiveFax is
installed on starts. When you want to display the Setup dialog
box, you can stop the LFdriver from the FAX Monitor.
a On the ActiveFax server, click Start > Programs >
ActiveFax > Monitor.
b If “Setup!” on the FAX Monitor menu bar is available, skip to
step c.
If “Setup!” is unavailable, click “Stop” on the LFdriver menu.
(Stopping the driver may take a few minutes.)
c On the menu bar, click “Setup!”
c
b