UNITY INSTALLATION GUIDE
40
Setting up the
Unity or
ActiveFax
server
In this section, you attach the system key, an expansion chassis
(if necessary), and other peripherals, then connect the phone
system and start the Unity or ActiveFax server.
We recommend that you connect the server to a dedicated
uninterruptible power supply. Contact the dealer for more
information.
A turnkey Unity server is configured for a specific hardware
setup. Do not add or change any hardware on the Unity server,
except to add memory, or voice or fax boards.
System key
The system key is programmed with the options and the number
of ports purchased for the system. Unity checks the system key
to activate the correct options; Unity does not start without the
key. The same is true of ActiveFax when it is installed on a sepa-
rate server.
Expansion chassis
Systems with a large number of ports may use an expansion
chassis to provide an adequate number of ISA or PCI slots. A
50-pin cable—connected to I/O bus extender boards in the Unity
server and the expansion chassis—connects the Unity server
and the chassis.
DO THIS SECTION?
TURNKEY
SYSTEM
YES NO
see
page
All configurations
✓
COMPONENT
SYSTEM
All configurations
✓
ACTIVEFAX SERVER
✓
To Next Page
Loading...
Need help?
General
