CHAPTER 3:
Installing a Unity system
49
Installing
Windows NT
Server
The following procedures describe how to install Windows NT
version 4.0 by using the disks that are currently shipping with
Unity. If you are using different disks or are installing Windows
2000, the installation process may differ.
NOTE: If you are setting up a separate ActiveFax server, you can
install Windows NT Workstation instead of Windows NT Server.
For more detailed information on individual steps in the installa-
tion process, see the Windows NT/2000 documentation that is
included with the software.
To install Windows NT Server 4.0
a Insert Microsoft Windows NT Server Setup Disk 1 in drive A.
b Start the server.
c Follow the on-screen instructions until you are prompted to
specify the partition on which to install Windows NT.
d If you are reinstalling Windows NT on the same partition
where Windows NT is already installed, select and delete
that partition, then continue with step e.
Otherwise, skip to step e.
e Select the partition on which to install Windows NT and
press ENTER.
f If you chose to delete a partition in step d, select “Format
the partition using the NTFS file system” and press ENTER,
then continue with step g.
Otherwise, skip to step g.
g Follow the on-screen prompts until you are prompted to
select a licensing mode.
h Click “Per seat” for the licensing mode, then click “Next” to
continue.
Continued
DO THIS SECTION?
TURNKEY
SYSTEM
YES NO
see
page
Voice mail only 80
Voice mail with LAN admin 54
Unified, one Exchange server
Unity server is a PDC 54
Unity server is a member
server
✓
Unified, existing Exchange site
✓
COMPONENT
SYSTEM
All configurations
✓
ACTIVEFAX SERVER
✓
To Next Page
Loading...
Need help?
General
