Citrix ADC MPX Series User Manual

Citrix ADC MPX
Find the SNIP address from the DHCP server
Look in the dhcpd.leases file for the last entry with the sysid of your appliance in the uid or client-
hostname field.
Example:
The following entry in a DHCP server’s dhcpd.leases file verifies the binding state of the appliance
whose sysid is 45eae1a8157e89b9314f.
1 lease 192.168.2.127 {
2
3 starts 3 2013/08/19 00:40:37;
4 ends 3 2013/08/19 06:40:37;
5 cltt 3 2013/08/19 00:40:37;
6 binding state active;
7 next binding state free;
8 hardware ethernet 00:d0:68:11:f4:d6;
9 uid ”45eae1a8157e89b9314f”;
10 client-hostname ”45eae1a8157e89b9314f”;
In the above example, the binding state is ACTIVE and the IP address assigned to the appliance is
192.168.2.127.
The following table describes DHCP-related CLI commands that you might want to use when config-
uring a new Citrix ADC appliance.
Table 2. Citrix ADC CLI commands for using DHCP with a new Citrix ADC appliance
Task At the Citrix ADC command prompt, type:
To verify the DHCP fetched details, such as IP
address, subnet mask, and gateway on the
appliance
> sh dhcpParams
To release the DHCP IP address and return it to
the IP address pool on the DHCP server when
the Citrix ADC configuration is complete
> release dhcpIP
Using DHCP when a configuration file is present
If you need to move a Citrix ADC appliance to a dierent subnet, such as from a testing environment
to a production environment, you can use DHCP to access an appliance that already has a configura-
tion file. Before moving the appliance, enable its DHCP client and save the configuration. As a result,
when the appliance restarts, it automatically polls the DHCP server for an IP address. If you did not en-
© 1999-2019 Citrix Systems, Inc. All rights reserved. 133

Citrix ADC MPX Series Specifications

General

Type	Application Delivery Controller
Memory	Up to 256 GB
Power Supply	Redundant
Product Series	MPX
Ports	10/25/40/100 Gbps Ethernet
Operating System	Citrix ADC
Management	Citrix ADM
Form Factor	Rack-mountable