Citrix ADC MPX Series User Manual

Citrix ADC MPX
Set up the destination address for SNMP events
The following command sets up a destination IP address for an SNMP event:
ipmitool lan alert set 1 1 ipaddr <x.x.x.x>
Where, <x.x.x.x> is the IP address to which the SNMP event is sent.
Specify an SNMP community string name
At the prompt, type:
ipmitool lan set 1 snmp <community string>
Install a certificate and key on the LOM GUI
November 18, 2019
Citrix recommends using HTTPS to access the LOM GUI. To use HTTPS, you must replace the default
SSL certificate with one from a trusted certificate authority and upload a private key to the LOM GUI.
To encrypt SNMP alerts, set up an SSL certificate and private key. In the GUI, navigate to Configu-
ration > SSL Certification and apply the SSL certificate and private key. See the Citrix ADC Secure
Deployment Guide for more information about how to securely deploy the LOM in your network. To
enable encryption and learn the security measures for LOM, see
Citrix ADC Secure Deployment Guide.
If you make a mistake, you must restore the BMC to the factory defaults to erase the certificate and
key. Use the following shell command:
1 ipmitool raw 0x30 0x40
Note: The certificate file must contain only the certificate. The certificate and key must not be in the
same file. Make sure that the certificate contains only the certificate and that the key file contains only
the key.
Upload a trusted certificate and private key by using the LOM GUI
1. Navigate to Configuration > SSL Certification.
© 1999-2019 Citrix Systems, Inc. All rights reserved. 143

Citrix ADC MPX Series Specifications

General

Type	Application Delivery Controller
Memory	Up to 256 GB
Power Supply	Redundant
Product Series	MPX
Ports	10/25/40/100 Gbps Ethernet
Operating System	Citrix ADC
Management	Citrix ADM
Form Factor	Rack-mountable