Citrix ADC MPX
The following components are visible on the back panel of the MPX 11515/11520/11530/11540/11542
appliance:
• 256 GB removable solid-state drive that is used to store the Citrix ADC soware.
• USB port (reserved for a future release).
• Power switch, which turns o power to the appliance, just as if you were to unplug the power
supply. Press the switch for five seconds to turn o the power.
• Non-maskable interrupt (NMI) Button that is used at the request of Technical Support and pro-
duces a core dump on the appliance. You must use a pen, pencil, or other pointed object to
press this red button, which is recessed to prevent unintentional activation.
• Two removable hard-disk drives that are used to store user data.
• Disable alarm button. This button is functional only when the appliance has two power sup-
plies.
Press this button to stop the power alarm from sounding when you have plugged the appliance
into only one power outlet or when one power supply is malfunctioning and you want to con-
tinue operating the appliance until it is repaired.
• Two power supplies, each rated at 960 watts, 110-220 volts. Maximum power consumption is
650 watts and typical power consumption is 500 watts, except on the MPX 11540T appliance
which has a maximum power consumption of 365 watts and typical power consumption of 300
watts.
For information about installing the rails, rack mounting the hardware, and connecting the cables,
see “Installing the Hardware.”
For information about performing initial configuration of your appliance, see “Initial Configuration.
© 1999-2019 Citrix Systems, Inc. All rights reserved. 45
To Next Page
Loading...
Need help?
General
