CITROEN 2005 C4-XSARA-XSARA PICASSO BERLINGO - Engine

105
ENGINE
SPECIAL FEATURES - TIGHTENING TORQUES (m.daN)
Cylinder block
Crankshaft bearing cap cover
Tightening method:
Pre-tighten the 10 screws (17)
(from 1 to 10) to 1
Pre-tighten the 14 screws (19)
(from 11 to 24) to 0,6
Tighten the 2 screws (18)
(inside the flywheel bell housing) to 0,8
Slacken the screws (17) by 180°
Tighten the 10 screws (17)
(from 1 to 10) to 3
Tighten the screws (17)
(from 1 to 10) by 140°
Tighten the 14 screws (19) (from 11 to 24) to 0,8
Engine: 9HX
B1DP1LLD
Sequence for tightening the screws (17), (18) and (19)
(17) Bearing cap fixing screws
(screw M9)
(18) Crankshaft bearing cap cover screws (screw M6)
(19) Crankshaft bearing cap cover screws (screw M6)
C4
Angl.-t2-page040-134-2005 9/01/06 10:11 Page 105