CITROEN 2005 C4-XSARA-XSARA PICASSO BERLINGO - Engine

221
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: 6FZ - RFN
Setting the timing (continued).
Turn the tensioner roller (8), using tool [5a] to go beyond slot «b».
Position the tool [5b] to lock the index «a» and remove the tool [5a].
Reposition the timing belt (7) on the crankshaft pulley.
Hold the timing belt (7) in place using tool [3].
Fit the timing belt (7) in place, respecting the following order:
- Guide roller (10).
- Inlet camshaft pulley (6).
- Exhaust camshaft pulley (5).
- Coolant pump (11).
-Tensioner roller (8).
NOTE: Make so that the belt (7) is as flush as possible with the exterior face of the various
pinions and rollers.
Remove:
- Tool [3].
- Tool [1] from the exhaust camshaft pulley.
- Tool [5b] from the tensioner roller (8).
Refit:
- The lower timing cover (4)
(by moving the engine).
- The crankshaft pulley (2).
- Screw (3) of the crankshaft pulley.
Tighten screw (3) to 4 ± 0,4 m.daN, then angular tighten to 53°±4°, tool [4].
B1EP1BCD B1EP1BDC
XSARA - XSARA PICASSO
Angl.-t2-page135-239-2005 9/01/06 10:14 Page 221