176
ENGINE
XSARA - XSARA PICASSO AUXILIARY EQUIPMENT DRIVE BELT
Engines: RHY - RHZ
Without air conditioning
B1BP1YKD
Tools.
[1] Belt tension adjusting square : (-).0188 J2
[2] Ø 4 mm peg : (-).0188.Q1
[3] Ø 2 mm peg : (-).0188.Q2
[4] Dynamic tensioner compression lever : (-).0188.Z
Removing.
Re-use of belt.
WARNING: Mark the direction the belt was fiited in case of re-use of the same belt.
Compress the tensioner roller (2) by action at «a»
(in anti-clockwise direction)
, tool [4].
Keep the tensioner roller (2) compressed and remove the belt.
No re-use of belt.
Compress the tensioner roller (2) by action at «a»
(in anti-clockwise direction)
, tool [4].
Peg using tool [2] at «b».
Keep the tensioner roller (2) compressed and remove the belt.
Loosen the screw (1).
To Next Page
Loading...
