214
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: RFN
Checking and setting the timing (continued).
Refitting.
Turn the tensioner roller (9), using tool [5a] to go past the notch «b».
Position the tool [5b] to lock the index «a» and remove the tool [5a].
Reposition the timing belt (10) on the crankshaft pinion (1).
Hold the timing belt in place (10) using tool [3].
Put the timing belt (10) in place, in the following sequence:
- Guide roller (12).
- Inlet camshaft pulley (7).
- Exhaust camshaft pulley (6).
- Coolant pump (11).
- Tensioner roller (9).
NOTE: Make sure that the timing belt (10) is as flush as possible with the outer faces of the
various pinions and rollers.
Remove tools [3], [1] and [5b].
Refit the lower timing cover (5), the pulley (2) and the screw (3) of the crankshaft pulley.
Tighten the screw (3) to 4 ± 0,4 m.daN.
Angular tighten 53°±4°, using tool [4].
B1EP1G9D
B1EP1GAC
C4
To Next Page
Loading...
