207
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: RFJ
Checking and setting the timing (continued).
Refitting.
Turn the tensioner roller (9), using tool [5a] to go past the notch «b».
Position the tool [5b] to lock the index «a» and remove the tool [5a].
NOTE: Check the presence of the crankshaft pinion keyway (12) before positioning the timing belt.
Reposition the timing belt (8) on the crankshaft pinion (1).
Hold the timing belt in place (8) using tool [3].
Put the timing belt (8) in place, in the following sequence:
- Guide roller (11).
- Inlet camshaft pulley (7).
- Exhaust camshaft pulley (6).
- Coolant pump (13).
- Tensioner roller (9).
NOTE: Make sure that the timing belt (8) is as flush as possible with the outer faces of the various
pinions and rollers.
Remove tools [3], [1] and [5b].
Refit the lower timing cover (5), the pulley (2) and the screw (3) of the crankshaft pulley.
Tighten the screw (3) to 4 ± 0,4 m.daN.
Angular tighten 40°±4°, using tool [4].
B1EP1G2D
B1EP1G3C
C4
To Next Page
Loading...
