238
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: 8HX - 8HZ
B1EP18KC
Setting the timing (continued).
Turn the tensioner roller to the right to bring the index «c» to position «d», using
a hexagonal spanner.
Tighten the screw (9) of the tensioner roller, tighten to 3 ± 0,3 m.daN.
Remove the tools [4] and [5].
Rotate the engine ten times
(check that the timing pinion is correctly up against
the crankshaft)
.
Check:
- The pegging of the camshaft.
- The crankshaft pinion.
- The fuel high pressure pump pinion (15).
- The correct positioning of the index of the dynamic tensioner.
If these are not correct, repeat the operation to position the timing belt.
Refit:
- The engine speed sensor (6).
- The belt retaining stop (5), tighten to 0,7 m.daN.
XSARA
To Next Page
Loading...
