178
ENGINE
XSARA - XSARA PICASSO
AUXILIARY EQUIPMENT DRIVE BELT
Engines: RHY - RHZ
With air conditioning
B1BP1YLD
Tools.
[1] Belt tension adjusting square : (-).0188 J2
[2] Ø 4 mm peg : (-).0188.Q1
[3] Ø 2 mm peg : (-).0188.Q2
[4] Dynamic tensioner compression lever : (-).0188.Z
Removal.
Re-use of belt.
WARNING: Mark the direction the belt was fitted in case of re-use of the same belt.
Compress the tensioner roller (7) by moving it at «c»
(in anti-clockwise direction)
, tool [4].
Hold the tensioner roller (7) compressed and remove the belt.
No re-use of belt.
Compress the tensioner roller (7) by moving it at «c»
(in anti-clockwise direction)
, tool [4].
Peg using tool [2], at «d».
Loosen the screw (6).
Bring the eccentric roller (5) towards the rear.
Tighten the screw (6) by hand.
Remove the belt.
To Next Page
Loading...
