277
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: RHR
Refitting.
Rotate the crankshaft ten times
(in the direction of rotation of the engine)
.
Peg the crankshaft, using tool [2] and the camshaft drive pinion, using tool [3].
Lock the flywheel, using tool [6].
Slacken the screw (8) of the auxiliaries drive pulley (7) and the screw (12) of
the tensioner roller (17).
Turn the tensioner roller
(clockwise)
, using a hexagonal spanner at «e».
Position the index «d» opposite the notch «f».
Tighten:
- The screw (12) of the tensioner roller (17) to 2,1 ± 0,2 m.daN.
- The auxiliaries drive pulley to 7 ± 0,7 m.daN.
Remove tools [2], [3] and [6].
Rotate the crankshaft two times
(in the direction of rotation of the engine)
.
Refit tools [2] and [3].
Check the position of the index «d», it should be opposite the notch «f».
B1EP1FKC
B1EP1FLC
C4
To Next Page
Loading...
