381
AXLES
SUSPENSION
STEERING
XSARA
REAR AXLE
- The front silentblocks are aligned at an angle of 45° in relation to the vehicle's axis.
- The rear silentblocks are in parallel with the vehicle's axis.
NOTE: There are two suppliers for the silentblocks:
- RBT, identified by a Green or Yellow painted dot on the side of the mounting.
- PAULSTRA, identified by a Black painted dot on the side of the mounting.
It is FORBIDDEN to swap components of different suppliers.
Operating clearance - X = 1 to 1.4 mm.
NOTE: The RH torsion bar can be identified
by 1 paint line.
The LH torsion bar can be identified by 2 paint
lines.
B3DP04UD
B3DP04TC
To Next Page
Loading...
