389
AXLES
SUSPENSION
STEERING
AXLE GEOMETRY
(*) = Difficult road conditions.
Compress the suspension to obtain the calculated values.
NOTE: The difference in height between the two sides should be less than 10 mm.
Measure the radius of the rear wheel: R2.
Calculate the dimension H2.
Measure the radius of the front wheel: R1.
Calculate the dimension H1 ou H1’.
Measurements at reference height
(the reference height of the vehicle is set as per the table below).
B3CP05BC B3CP05AC
XSARA PICASSO
Front axle Rear axle
Front axle
Rear axle
Vehicles all engine versions (except CRD (*))
H1 = R1 – L1 or H1’ = R1 – L1’
L1 = 90,5 mm
L1’ = 124 mm
L2 = 8,5 mm
H2 = R2 + L2
B3DP079C
Value at reference height (-8/+3 mm)
Value at reference height (+10/-3 mm)
To Next Page
Loading...
